Radial head arthroplasty restores axial construct stiffness in a Monteggia-like injury model: a biomechanical study.
- 1Center for Orthopedic and Trauma Surgery, University Hospital Cologne, Cologne, Germany. [email protected].
- 2Center for Orthopedic and Trauma Surgery, University Hospital Cologne, Cologne, Germany.
Abstract
Introduction
Monteggia-like lesions are rare but complex elbow injuries involving fractures of both the proximal ulna and the radial head. While the influence of ulnar alignment and soft tissue integrity on radial head stability has been extensively studied, the effect of radial head integrity on the stability of ulnar fixation remains poorly understood. Given the high rates of nonunion and revision surgery after proximal ulna fractures, improved understanding of forearm biomechanics in these combined injuries is highly clinically relevant as it influences the surgical strategy in primary care of these injuries. Accordingly, this study aimed to evaluate the biomechanical impact of radial head resection and radial head arthroplasty on forearm stiffness in a simulated Monteggia-like injury model. We hypothesized that radial head resection would reduce construct stiffness compared with both the native state and radial head arthroplasty, and that arthroplasty would partially restore stiffness toward native levels MATERIALS AND METHODS: Eight fresh-frozen human cadaveric elbow specimens were biomechanically tested under axial loading. After baseline testing in the native state, a standardized segmental comminution model was created and stabilized using locking plate osteosynthesis. Sequential testing was then performed after radial head resection and after implantation of a modular radial head prosthesis. Specimens were loaded cyclically up to 450 N for 1,000 cycles with the elbow positioned at 30° of flexion. Construct stiffness was calculated and compared between testing conditions.Results
Mean construct stiffness in the native state was 49.3 ± 4.29 N/mm and decreased significantly after creation and fixation of the ulnar defect (36.05 ± 6.71 N/mm). Radial head resection resulted in a further significant reduction in stiffness (25.83 ± 6.65 N/mm). Following radial head arthroplasty, stiffness increased to 33.8 ± 7.89 N/mm, representing a significant improvement compared with the resection state (p ≤ 0.0026). No significant difference was observed between stiffness after prosthesis implantation and the condition with intact radial head and stabilized ulna.Conclusion
Radial head integrity significantly contributes to forearm stiffness in Monteggia-like lesions. Radial head arthroplasty partially restores biomechanical stability after resection and may alter load distribution in a manner that could be relevant for fixation durability. These findings support the need to address the radial column to optimize stability in complex elbow injuries.Level of evidence
Biomechanical study.
Related
- Minor lateral pedicle wall breach patterns reduce construct stiffness without substantial stress amplification in posterior pedicle screw fixation
- Burch-Schneider Ring Alone Vs Cup-Cage Construct in Massive Acetabular Bone Defect in Revision Total Hip Arthroplasty
- From structural repair to biomechanical compatibility: Aortic stiffness after open and endovascular aortic repair.
- Network analysis reveals that total hip arthroplasty restores shared segmental motion before segmental differentiation.
- A biomechanical comparison of su5ture with a lateral plate and cerclage wire and suture constructs for lesser tuberosity osteotomy repair in stemless anatomic total shoulder arthroplasty
BibTeX
@article{weber2026radial,
title = {{Radial head arthroplasty restores axial construct stiffness in a Monteggia-like injury model: a biomechanical study.}},
author = {Marc Maximilian Weber and Jan P Hockmann and Till A Rosenkranz and Tim Leschinger and Lars Peter Müller and Valentin Rausch},
journal = {Archives of orthopaedic and trauma surgery},
year = {2026},
month = oct,
doi = {10.1007/s00402-026-06515-w},
url = {https://europepmc.org/article/MED/42955368},
note = {CC BY},
}
RIS
TY - JOUR
TI - Radial head arthroplasty restores axial construct stiffness in a Monteggia-like injury model: a biomechanical study.
AU - Marc Maximilian Weber
AU - Jan P Hockmann
AU - Till A Rosenkranz
AU - Tim Leschinger
AU - Lars Peter Müller
AU - Valentin Rausch
PY - 2026
DA - 2026/10/28
JO - Archives of orthopaedic and trauma surgery
DO - 10.1007/s00402-026-06515-w
UR - https://europepmc.org/article/MED/42955368
AB - Introduction Monteggia-like lesions are rare but complex elbow injuries involving fractures of both the proximal ulna and the radial head. While the influence of ulnar alignment and soft tissue integrity on radial head stability has been extensively studied, the effect of radial head integrity on the stability of ulnar fixation remains poorly understood. Given the high rates of nonunion and revision surgery after proximal ulna fractures, improved understanding of forearm biomechanics in these combined injuries is highly clinically relevant as it influences the surgical strategy in primary care of these injuries. Accordingly, this study aimed to evaluate the biomechanical impact of radial head resection and radial head arthroplasty on forearm stiffness in a simulated Monteggia-like injury model. We hypothesized that radial head resection would reduce construct stiffness compared with both the native state and radial head arthroplasty, and that arthroplasty would partially restore stiffness toward native levels MATERIALS AND METHODS: Eight fresh-frozen human cadaveric elbow specimens were biomechanically tested under axial loading. After baseline testing in the native state, a standardized segmental comminution model was created and stabilized using locking plate osteosynthesis. Sequential testing was then performed after radial head resection and after implantation of a modular radial head prosthesis. Specimens were loaded cyclically up to 450 N for 1,000 cycles with the elbow positioned at 30° of flexion. Construct stiffness was calculated and compared between testing conditions.Results Mean construct stiffness in the native state was 49.3 ± 4.29 N/mm and decreased significantly after creation and fixation of the ulnar defect (36.05 ± 6.71 N/mm). Radial head resection resulted in a further significant reduction in stiffness (25.83 ± 6.65 N/mm). Following radial head arthroplasty, stiffness increased to 33.8 ± 7.89 N/mm, representing a significant improvement compared with the resection state (p ≤ 0.0026). No significant difference was observed between stiffness after prosthesis implantation and the condition with intact radial head and stabilized ulna.Conclusion Radial head integrity significantly contributes to forearm stiffness in Monteggia-like lesions. Radial head arthroplasty partially restores biomechanical stability after resection and may alter load distribution in a manner that could be relevant for fixation durability. These findings support the need to address the radial column to optimize stability in complex elbow injuries.Level of evidence Biomechanical study.
SN - 0936-8051
SN - 1434-3916
ER -