Solution-plasma-derived Fe–N–C/NiFe-LDH composite for bifunctional oxygen electrocatalysis: effects of surface modification and LDH growth
- 1Materials Science and Engineering, Graduate School of Engineering and Science, Shibaura Institute of Technology Toyosu, Koto-Ku Tokyo 135-8548 Japan
- 2College of Engineering, Shibaura Institute of Technology Toyosu, Koto-Ku Tokyo 135-8548 Japan
Abstract
Herein, a noble-metal-free bifunctional electrocatalyst was synthesized by growing NiFe layered double hydroxide (NiFe-LDH) nanosheets via a hydrothermal method on a solution-plasma-derived Fe–N–C substrate for rechargeable air-battery applications. Nitric acid modification increased the amount of oxygen-containing surface groups, including O–C
Created by potrace 1.16, written by Peter Selinger 2001-2019
O species, which can serve as anchoring sites for subsequent LDH nucleation. However, acid treatment also decreased the surface N content and the N 1s component assigned to Fe–N coordination, resulting in a trade-off between surface functionalization and preservation of ORR-active structures. SEM/EDS and XRD supported the formation of a NiFe-LDH phase on the Fe–N–C-based support, while the approximately +0.3 eV Ni 2p binding-energy shift observed by XPS indicated a change in the local chemical/electronic environment upon composite formation. The present data, however, do not directly establish an atomically intimate heterointerface or the direction and rate of interfacial charge transfer. Under the measurement conditions used in this study, Fe–N–C@NiFe-LDH exhibited an ORR half-wave potential (E1/2) of 0.849 V vs. RHE and an OER potential at 10 mA cm−2 (Ej=10) of 1.61 V, corresponding to an overall potential gap (ΔE) of 0.76 V. In a short-term ORR durability test, the composite retained 81.7% of its current after 10 000 s and showed a 23 mV negative shift in E1/2. In contrast, during OER durability testing, Ej=10 shifted positively by 95 mV after 1000 potential cycles, indicating that the initial OER enhancement was not fully maintained. These results highlight the need to balance surface functionalization, preservation of ORR-active structures, NiFe-LDH loading and coverage, and structural durability in the design of Fe–N–C/NiFe-LDH bifunctional oxygen electrocatalysts.
Related
- Electronic modulation of confined NiFe nanoalloys in hierarchical C3N4/CNT frameworks for bifunctional oxygen electrocatalysis
- Catechol-functionalized carbon nanofibers enabling ultrafine CoFe2O4 nanorods for high-performance bifunctional oxygen electrocatalysis and Zn–air batteries
- High-Performing Unitized Regenerative Fuel Cell Using PGM-Free Bifunctional Catalysts from Waste-Derived Carbon
- Waste-Derived Natural Polymer Biosorbents for Toxic Metal Ions: Structure–Sorption Relationships, Modification Strategies, and Prospects for Solid-Phase Sensing
- Rapid acid-catalyzed synthesis and surface modification of isopropanol-derived carbon dots
BibTeX
@article{ogihara2026solutionplasmaderived,
title = {{Solution-plasma-derived Fe–N–C/NiFe-LDH composite for bifunctional oxygen electrocatalysis: effects of surface modification and LDH growth}},
author = {Kentaro Ogihara and Kouki Yamamoto and Hayato Takada and Takahiro Ishizaki},
journal = {RSC advances},
year = {2026},
month = oct,
doi = {10.1039/d6ra07919a},
url = {https://europepmc.org/article/PMC/PMC13673662},
note = {CC BY},
}
RIS
TY - JOUR
TI - Solution-plasma-derived Fe–N–C/NiFe-LDH composite for bifunctional oxygen electrocatalysis: effects of surface modification and LDH growth
AU - Kentaro Ogihara
AU - Kouki Yamamoto
AU - Hayato Takada
AU - Takahiro Ishizaki
PY - 2026
DA - 2026/10/16
JO - RSC advances
DO - 10.1039/d6ra07919a
UR - https://europepmc.org/article/PMC/PMC13673662
AB - Herein, a noble-metal-free bifunctional electrocatalyst was synthesized by growing NiFe layered double hydroxide (NiFe-LDH) nanosheets via a hydrothermal method on a solution-plasma-derived Fe–N–C substrate for rechargeable air-battery applications. Nitric acid modification increased the amount of oxygen-containing surface groups, including O–C Created by potrace 1.16, written by Peter Selinger 2001-2019 O species, which can serve as anchoring sites for subsequent LDH nucleation. However, acid treatment also decreased the surface N content and the N 1s component assigned to Fe–N coordination, resulting in a trade-off between surface functionalization and preservation of ORR-active structures. SEM/EDS and XRD supported the formation of a NiFe-LDH phase on the Fe–N–C-based support, while the approximately +0.3 eV Ni 2p binding-energy shift observed by XPS indicated a change in the local chemical/electronic environment upon composite formation. The present data, however, do not directly establish an atomically intimate heterointerface or the direction and rate of interfacial charge transfer. Under the measurement conditions used in this study, Fe–N–C@NiFe-LDH exhibited an ORR half-wave potential (E1/2) of 0.849 V vs. RHE and an OER potential at 10 mA cm−2 (Ej=10) of 1.61 V, corresponding to an overall potential gap (ΔE) of 0.76 V. In a short-term ORR durability test, the composite retained 81.7% of its current after 10 000 s and showed a 23 mV negative shift in E1/2. In contrast, during OER durability testing, Ej=10 shifted positively by 95 mV after 1000 potential cycles, indicating that the initial OER enhancement was not fully maintained. These results highlight the need to balance surface functionalization, preservation of ORR-active structures, NiFe-LDH loading and coverage, and structural durability in the design of Fe–N–C/NiFe-LDH bifunctional oxygen electrocatalysts.
SN - 2046-2069
ER -