Rapid growth of a pit-free (011) β-Ga2O3 homoepitaxial layer with very low residual Si and Cl concentrations by HCl-based halide vapor phase epitaxy
- 1Research Center for Electronic and Optical Materials, National Institute for Materials Science, Tsukuba, Japan
Abstract
We report the rapid growth of pit-free (011) β-Ga2O3 homoepitaxial layers with very low residual [Si] and [Cl] by HCl-based halide vapor phase epitaxy (HCl-HVPE) in which GaCl was generated from Ga and HCl. Along with the GaCl and O2 growth precursors, additional HCl was introduced directly into the growth zone to suppress parasitic gas-phase reactions. The effects of O2 and additional HCl partial pressures on residual impurity concentrations were systematically investigated. The [Si] decreased sharply with increasing O2 partial pressure before reaching saturation, whereas it increased monotonically with additional HCl partial pressure and fell below the secondary ion mass spectrometry detection limit (1 × 1015 cm−3) in the absence of additional HCl. Thermodynamic analysis of SiO2 etching by H2 and HCl qualitatively reproduced these trends and suggested that residual Si originates predominantly from HCl-induced etching of quartz components in the source zone in the reactor. Even without additional HCl, increasing the GaCl supply enabled a growth rate of 13 μm/h, comparable to that previously achieved with additional HCl, while maintaining [Si] below the detection limit and [Cl] below 2 × 1015 cm−3, without particle-induced surface degradation. Furthermore, no pit formation was observed in the absence of additional HCl, and the pits were found to originate from substrate pre-etching by additional HCl before growth. These findings demonstrate that HCl-HVPE enables rapid homoepitaxy of pit-free (011) β-Ga2O3 layers with very low residual impurity concentrations, offering a promising route toward cost-effective vertical β-Ga2O3 power devices.
Related
- High-concentration Ge doping of (001) β-Ga2O3 by halide vapor phase epitaxy beyond the practical Si doping limit
- Ligand-Dictated Anisotropic Growth of Cesium Tin Bromide Nanowires at Low Ligand Concentrations
- In situ monitoring of solvent dependent CsPbBr3 nanorod growth from lead halide precursors
- Engineering shallow and deep level defects in κ-Ga2O3 thin films: comparing metal-organic vapour phase epitaxy to molecular beam epitaxy and the effect of annealing treatments
- Unveiling Graphitic Carbon Nitride in Hexagonal Boron Nitride Epitaxy on Sapphire
BibTeX
@article{oshima2026rapid,
title = {{Rapid growth of a pit-free (011) β-Ga2O3 homoepitaxial layer with very low residual Si and Cl concentrations by HCl-based halide vapor phase epitaxy}},
author = {Yuichi Oshima and Takayoshi Oshima},
journal = {Science and Technology of Advanced Materials},
year = {2026},
month = oct,
doi = {10.1080/14686996.2026.2751773},
url = {https://doi.org/10.1080/14686996.2026.2751773},
note = {CC BY 4.0},
}
RIS
TY - JOUR
TI - Rapid growth of a pit-free (011) β-Ga2O3 homoepitaxial layer with very low residual Si and Cl concentrations by HCl-based halide vapor phase epitaxy
AU - Yuichi Oshima
AU - Takayoshi Oshima
PY - 2026
DA - 2026/10/22
JO - Science and Technology of Advanced Materials
DO - 10.1080/14686996.2026.2751773
UR - https://doi.org/10.1080/14686996.2026.2751773
AB - We report the rapid growth of pit-free (011) β-Ga2O3 homoepitaxial layers with very low residual [Si] and [Cl] by HCl-based halide vapor phase epitaxy (HCl-HVPE) in which GaCl was generated from Ga and HCl. Along with the GaCl and O2 growth precursors, additional HCl was introduced directly into the growth zone to suppress parasitic gas-phase reactions. The effects of O2 and additional HCl partial pressures on residual impurity concentrations were systematically investigated. The [Si] decreased sharply with increasing O2 partial pressure before reaching saturation, whereas it increased monotonically with additional HCl partial pressure and fell below the secondary ion mass spectrometry detection limit (1 × 1015 cm−3) in the absence of additional HCl. Thermodynamic analysis of SiO2 etching by H2 and HCl qualitatively reproduced these trends and suggested that residual Si originates predominantly from HCl-induced etching of quartz components in the source zone in the reactor. Even without additional HCl, increasing the GaCl supply enabled a growth rate of 13 μm/h, comparable to that previously achieved with additional HCl, while maintaining [Si] below the detection limit and [Cl] below 2 × 1015 cm−3, without particle-induced surface degradation. Furthermore, no pit formation was observed in the absence of additional HCl, and the pits were found to originate from substrate pre-etching by additional HCl before growth. These findings demonstrate that HCl-HVPE enables rapid homoepitaxy of pit-free (011) β-Ga2O3 layers with very low residual impurity concentrations, offering a promising route toward cost-effective vertical β-Ga2O3 power devices.
SN - 1468-6996
SN - 1878-5514
ER -