Development and Evaluation of Filtration Performance of ZnO-Doped PEI Composite Membranes
- 1Department of Environmental Engineering, Faculty of Engineering, Istanbul University-Cerrahpasa, Avcılar, 34320 Istanbul, Turkey
Abstract
Polyetherimide (PEI)-based membranes were fabricated by phase inversion to examine the effects of zinc oxide (ZnO) nanoparticles and polyvinylpyrrolidone (PVP) on membrane structure, wettability, permeation, and fouling behavior. Six formulations comprising neat PEI, PEI/PVP, two ZnO loadings (0.5 and 1 wt.%), and the corresponding PVP/ZnO combinations were characterized by Fourier-transform infrared (FTIR) spectroscopy, scanning electron microscopy (SEM), casting-solution viscosity, contact angle, water content, gravimetric porosity estimation, effective pore-radius estimation, and sequential distilled-water/lake-water filtration. The additives produced marked but non-monotonic changes in solution viscosity, morphology, and surface wettability. PEI/PVP/ZnO-0.5 exhibited the lowest contact angle (approximately 35°), whereas PEI/PVP/ZnO-1 showed the smallest lake-water flux decline and the lowest total (approximately 4%) and irreversible (approximately 1%) fouling ratios. The results indicate that the effects of ZnO loading depend strongly on the presence of PVP and that wettability alone does not explain the observed fouling response. Under the present short-term filtration conditions, PEI/PVP/ZnO-1 provided the most favorable antifouling performance among the formulations tested.
Related
- Macroporous PES Composite Membranes Built on an sPES-Containing Asymmetric Platform for Improved Fermentation-Broth Filtration.
- Highly efficient MOF-808/polyethersulfone mixed matrix membranes for methyl orange filtration.
- Multilayer membranes of graphene oxide nanosheets on cellulose filter papers for high-flux water filtration and high proton conductivity.
- Photo-induced interfacial charge transfer in solar-responsive PVDF composite membranes
- Zinc oxide-coated coconut shell biochar-filled polylactic acid composite membranes for methylene blue removal from aqueous solutions.
BibTeX
@article{demirkol2026development,
title = {{Development and Evaluation of Filtration Performance of ZnO-Doped PEI Composite Membranes}},
author = {Güler Türkoğlu Demirkol},
journal = {Polymers},
year = {2026},
month = oct,
doi = {10.3390/polym18202499},
url = {https://www.mdpi.com/2073-4360/18/20/2499},
note = {CC BY 4.0},
}
RIS
TY - JOUR
TI - Development and Evaluation of Filtration Performance of ZnO-Doped PEI Composite Membranes
AU - Güler Türkoğlu Demirkol
PY - 2026
DA - 2026/10/13
JO - Polymers
DO - 10.3390/polym18202499
UR - https://www.mdpi.com/2073-4360/18/20/2499
AB - Polyetherimide (PEI)-based membranes were fabricated by phase inversion to examine the effects of zinc oxide (ZnO) nanoparticles and polyvinylpyrrolidone (PVP) on membrane structure, wettability, permeation, and fouling behavior. Six formulations comprising neat PEI, PEI/PVP, two ZnO loadings (0.5 and 1 wt.%), and the corresponding PVP/ZnO combinations were characterized by Fourier-transform infrared (FTIR) spectroscopy, scanning electron microscopy (SEM), casting-solution viscosity, contact angle, water content, gravimetric porosity estimation, effective pore-radius estimation, and sequential distilled-water/lake-water filtration. The additives produced marked but non-monotonic changes in solution viscosity, morphology, and surface wettability. PEI/PVP/ZnO-0.5 exhibited the lowest contact angle (approximately 35°), whereas PEI/PVP/ZnO-1 showed the smallest lake-water flux decline and the lowest total (approximately 4%) and irreversible (approximately 1%) fouling ratios. The results indicate that the effects of ZnO loading depend strongly on the presence of PVP and that wettability alone does not explain the observed fouling response. Under the present short-term filtration conditions, PEI/PVP/ZnO-1 provided the most favorable antifouling performance among the formulations tested.
SN - 2073-4360
ER -