Eco-friendly activated carbon derived from pomegranate peel for amoxicillin removal: batch adsorption, kinetic modeling, and thermodynamics
- 1Department of Chemical Engineering, Faculty of Engineering, Afyon Kocatepe University, Afyonkarahisar, Turkey. [email protected]
Abstract
Activated carbon derived from waste pomegranate peels was investigated for the removal of amoxicillin (AMX) from aqueous solutions. The prepared adsorbent exhibited a high BET surface area (1307 m²/g) and a well-developed micro-mesoporous structure. Under optimal conditions (pH 2, 0.05 g, 25 °C, 50 mg/L), a maximum removal efficiency of 97% was achieved, while 87% removal was maintained at near-neutral pH (pH 6). Increasing the initial concentration reduced removal efficiency due to adsorption site saturation, whereas increasing temperature decreased adsorption, confirming the exothermic nature of the process. Kinetic studies showed that the pseudo-second-order model provided the best fit, indicating that surface-controlled interactions govern the adsorption rate. Equilibrium data were better described by the Freundlich model, suggesting heterogeneous adsorption behavior, although the Langmuir model also indicated a high monolayer adsorption capacity (qₘₐₓ = 100 mg g⁻¹). Thermodynamic parameters (ΔG° = -6.13 to - 5.16 kj/mol, ΔH° = -15.59 kj/mol, ΔS° = -32.29 J/mol K) confirmed that the adsorption process is spontaneous and exothermic. The relatively low ΔH° value indicates that adsorption is predominantly governed by physisorption mechanisms. Overall, the results demonstrate that this low-cost and sustainable adsorbent is a promising alternative for efficient antibiotic removal from water.
Related
- Efficient removal of regorafenib from aqueous solutions using KOH-activated hazelnut husk-derived activated carbon: adsorption mechanism, kinetics, isotherms and thermodynamics
- New insight into the eco-friendly synthesis of MgO NPs using olive pomace extract: combined experimental and DFT study for Congo red adsorption
- Humidity-dependent formaldehyde adsorption on porous frameworks: A comparative study of MOFs, zeolites, and activated carbon
- Extended evaluation of activated carbon-embedded glucomannan membranes for the adsorption of structurally and charge-distinct dyes.
- Adsorption of crystal violet and malachite green onto dibarium magnesium orthoborate (Ba₂Mg(BO₃)₂): equilibrium, kinetics and thermodynamics.
BibTeX
@article{yılmaz2026ecofriendly,
title = {{Eco-friendly activated carbon derived from pomegranate peel for amoxicillin removal: batch adsorption, kinetic modeling, and thermodynamics}},
author = {Nazan Yılmaz},
journal = {Scientific Reports},
year = {2026},
month = may,
doi = {10.1038/s41598-026-51191-w},
url = {https://doi.org/10.1038/s41598-026-51191-w},
note = {CC BY},
}
RIS
TY - JOUR
TI - Eco-friendly activated carbon derived from pomegranate peel for amoxicillin removal: batch adsorption, kinetic modeling, and thermodynamics
AU - Nazan Yılmaz
PY - 2026
DA - 2026/05/23
JO - Scientific Reports
DO - 10.1038/s41598-026-51191-w
UR - https://doi.org/10.1038/s41598-026-51191-w
AB - Activated carbon derived from waste pomegranate peels was investigated for the removal of amoxicillin (AMX) from aqueous solutions. The prepared adsorbent exhibited a high BET surface area (1307 m²/g) and a well-developed micro-mesoporous structure. Under optimal conditions (pH 2, 0.05 g, 25 °C, 50 mg/L), a maximum removal efficiency of 97% was achieved, while 87% removal was maintained at near-neutral pH (pH 6). Increasing the initial concentration reduced removal efficiency due to adsorption site saturation, whereas increasing temperature decreased adsorption, confirming the exothermic nature of the process. Kinetic studies showed that the pseudo-second-order model provided the best fit, indicating that surface-controlled interactions govern the adsorption rate. Equilibrium data were better described by the Freundlich model, suggesting heterogeneous adsorption behavior, although the Langmuir model also indicated a high monolayer adsorption capacity (qₘₐₓ = 100 mg g⁻¹). Thermodynamic parameters (ΔG° = -6.13 to - 5.16 kj/mol, ΔH° = -15.59 kj/mol, ΔS° = -32.29 J/mol K) confirmed that the adsorption process is spontaneous and exothermic. The relatively low ΔH° value indicates that adsorption is predominantly governed by physisorption mechanisms. Overall, the results demonstrate that this low-cost and sustainable adsorbent is a promising alternative for efficient antibiotic removal from water.
SN - 2045-2322
ER -