Plastic mulching consistently improves brinjal performance, but drip irrigation benefits are soil dependent: A two-location field study
- 1Department of Agronomy, Bangladesh Agricultural University, Mymensingh, Bangladesh
- 2RDRS-Bangladesh, Rangpur, Bangladesh
- 3School of Agriculture, Food and Wine, Adelaide University, Adelaide, Australia
Abstract
Brinjal (Solanum melongena L.) requires considerable soil moisture throughout its life cycle, therefore, its cultivation in water constraint area is difficult. Though different soil moisture conservation technologies and lower water use irrigation systems have been developed for crop cultivation, their successful deployment largely depends on the locality, especially on soil characteristics. This study evaluated the effects of irrigation regimes, mulching practices, and their combination on growth, stress physiology and irrigation water use efficiency (IWUE) of brinjal across two field locations with contrasting soil conditions. Location 1 had coarser soil, lower nutrient and organic matter content profiles and lower water-holding capacity than location 2. The experiment comprised three irrigation levels [rainfed (I0), conventional furrow irrigation (IC), and drip irrigation (ID)] and three mulching treatments [no mulch (M0), straw mulch (MS), and plastic mulch (MP)] with three replications at both locations. Irrigation and mulching both significantly influenced growth, stress indicators, fruit yield, and IWUE, though the effects of the treatment on these parameters varied between locations. At Location 1, drip irrigation (ID) produced a fruit yield of 8.90 ± 5.68 t ha−1, with considerable variability among replicates, and did not differ significantly (p = 0.88) from conventional furrow irrigation (IC) or the rainfed treatment (I0). In contrast, at location 2, drip irrigation outperformed (21.88 ± 9.44 t ha−1) other treatments, being 117% and 32% higher than I0 and IC, respectively. Plastic mulching (MP) improved growth, reduced drought stress and increased yield compared to MS and M0 at both locations. The highest yield at location 1 (23.18 ± 6.62 t ha−1) occurred under IC × MP, while the highest yield at location 2 (32.93 ± 1.62 t ha−1) was achieved under ID × MP. IWUE peaked at 38.84 kg ha−1 mm−1 (IC × MP) in location 1 and 65.87 kg ha−1 mm−1 (ID × MP) in location 2. A linear mixed model estimated that plastic mulch increased yield by ~10.63 t ha−1 (95% CI: 6.58–14.68 t ha−1, p < 0.001) over no mulch, and IC × MP produced a synergistic yield gain of 11.03 t ha−1 (95% CI: 5.3–16.76 t ha−1, p = 0.003) over the control. Overall, plastic mulching consistently enhanced brinjal performance, while the benefit of drip irrigation was soil-dependent and was most evident in the higher water-retention field.
Related
- Milk-derived casein glycomacropeptide improves colonic mucus function under Western-style diet feeding in a sialylation-dependent manner
- Multi-Omics Analyses Identify Candidate Genes Associated With Stage-Specific Quality Formation in Mulching-Treated Moso Bamboo Shoots.
- Adaptive Milling: imaging feedback-driven automated fabrication of consistently thin cryo-lamellae
- Distinct transcriptional remodeling of immune and metabolic pathways in severe undernutrition during latent tuberculosis infection does not consistently predict tuberculosis progression across independent cohorts
- Convergence is not correctness: context-dependent performance of enhanced-sampling methods across biological complexity
BibTeX
@article{nayan2026plastic,
title = {{Plastic mulching consistently improves brinjal performance, but drip irrigation benefits are soil dependent: A two-location field study}},
author = {Md. Nayan and F. M. Jamil Uddin and Rounak Islam and Pronomi Paul Sutapa and Pallab Goswami and Swapan Kumar Paul and Tamara Jackson and Md. Harun Rashid},
journal = {PLOS One},
year = {2026},
month = oct,
doi = {10.1371/journal.pone.0360413},
url = {https://doi.org/10.1371/journal.pone.0360413},
note = {CC BY 4.0},
}
RIS
TY - JOUR
TI - Plastic mulching consistently improves brinjal performance, but drip irrigation benefits are soil dependent: A two-location field study
AU - Md. Nayan
AU - F. M. Jamil Uddin
AU - Rounak Islam
AU - Pronomi Paul Sutapa
AU - Pallab Goswami
AU - Swapan Kumar Paul
AU - Tamara Jackson
AU - Md. Harun Rashid
PY - 2026
DA - 2026/10/27
JO - PLOS One
DO - 10.1371/journal.pone.0360413
UR - https://doi.org/10.1371/journal.pone.0360413
AB - Brinjal (Solanum melongena L.) requires considerable soil moisture throughout its life cycle, therefore, its cultivation in water constraint area is difficult. Though different soil moisture conservation technologies and lower water use irrigation systems have been developed for crop cultivation, their successful deployment largely depends on the locality, especially on soil characteristics. This study evaluated the effects of irrigation regimes, mulching practices, and their combination on growth, stress physiology and irrigation water use efficiency (IWUE) of brinjal across two field locations with contrasting soil conditions. Location 1 had coarser soil, lower nutrient and organic matter content profiles and lower water-holding capacity than location 2. The experiment comprised three irrigation levels [rainfed (I0), conventional furrow irrigation (IC), and drip irrigation (ID)] and three mulching treatments [no mulch (M0), straw mulch (MS), and plastic mulch (MP)] with three replications at both locations. Irrigation and mulching both significantly influenced growth, stress indicators, fruit yield, and IWUE, though the effects of the treatment on these parameters varied between locations. At Location 1, drip irrigation (ID) produced a fruit yield of 8.90 ± 5.68 t ha−1, with considerable variability among replicates, and did not differ significantly (p = 0.88) from conventional furrow irrigation (IC) or the rainfed treatment (I0). In contrast, at location 2, drip irrigation outperformed (21.88 ± 9.44 t ha−1) other treatments, being 117% and 32% higher than I0 and IC, respectively. Plastic mulching (MP) improved growth, reduced drought stress and increased yield compared to MS and M0 at both locations. The highest yield at location 1 (23.18 ± 6.62 t ha−1) occurred under IC × MP, while the highest yield at location 2 (32.93 ± 1.62 t ha−1) was achieved under ID × MP. IWUE peaked at 38.84 kg ha−1 mm−1 (IC × MP) in location 1 and 65.87 kg ha−1 mm−1 (ID × MP) in location 2. A linear mixed model estimated that plastic mulch increased yield by ~10.63 t ha−1 (95% CI: 6.58–14.68 t ha−1, p < 0.001) over no mulch, and IC × MP produced a synergistic yield gain of 11.03 t ha−1 (95% CI: 5.3–16.76 t ha−1, p = 0.003) over the control. Overall, plastic mulching consistently enhanced brinjal performance, while the benefit of drip irrigation was soil-dependent and was most evident in the higher water-retention field.
SN - 1932-6203
ER -